Land Pride SGC06, Руководство оператора

Страница: 24 / 34

Section 3: Operating Procedures
SGC0660 Claw Grapple 380-164M 6/17/21
20
Table of Contents
9. When traveling over a ramp or incline, keep load on
the “uphill” side of tractor.
10. When possible, travel straight up and down grades,
ramps, and inclines. Avoid making turns on grades,
ramps, and inclines.
11. Raise or lower load only when stopped, never while
traveling.
12. Slow down when traveling over rough or hilly terrain.
13. Do not transport loads on public roadways.
14. Transport on public roadways without a load and
transport in such a way that faster moving vehicles
may pass you safely.
15. Plan your route to avoid heavy traffic.
Releasing A Load
1. Be sure to read and understand all safety alerts
under “Operating Safety” on page 17.
2. Stop in front of desired location.
3. Slowly raise load to required height.
4. Move forward slowly checking to make sure grapple
and load clears all obstacles.
5. Stop forward movement when load is positioned over
its release location.
6. Releasing load requires a combination of tilting front
of grapple down, raising upper jaw, and raising
loader arms. The order in which the load is released
will vary depending on type of material being
released. The most important objective is to have the
load under control throughout the release.
7. Once load has settled onto the pile, slowly back up
making sure grapple clears all objects and there are
not any pedestrians or other traffic behind or on
either side.
8. Leave enough clearance when turning and/or
lowering the grapple so that it does not make contact
with obstacles such as vehicles, buildings, trees, or
fences.
9. Lower grapple to transporting height (low to the
ground) before moving again.
Ripping Out Bushes
1. Be sure to read and understand all safety alerts
under “Operating Safety” on page 17.
2. Open upper claw halfway.
3. Rotate front of grapple down while lowering unit until
upper teeth extend into the ground on the far side of
the bush and lower teeth are on the near side.
4. Close grapple claws around the roots of the bush.
5. Raise grapple up to rip bush from ground.
Break Sod With Lower Jaw
1. Be sure to read and understand all safety alerts
under “Operating Safety” on page 17.
2. Open upper jaw halfway.
3. Lower grapple until bottom teeth start to go into the
ground. Do not go very deep into the ground.
4. Drive forward to break up sod and push debris ahead
of attachment.
Back Raking With Upper Jaw
1. Be sure to read and understand all safety alerts
under “Operating Safety” on page 17.
2. Open upper jaw fully and rotate front of grapple down
while lowering unit until the tips of the upper teeth
touch the ground.
3. Back-up to rake loose sticks and debris into a pile.
4. For instructions on how to pick-up the raked pile, see
“Picking-Up A Load” on page 19.
IMPORTANT:
Do not operate attachment with lower
teeth extending very deep into the ground. Doing so
can damage equipment.
IMPORTANT:
Check full range of motion before
rotating attachment down to back rake. See
“Equipment Clearances”
on page 14.