Land Pride SGC06, Руководство оператора

Страница: 14 / 34

Section 1: Assembly & Set-Up
SGC0660 Claw Grapple 380-164M 6/17/21
10
Table of Contents
Park Stand Rotated Down (Left-Hand Shown)
Figure 1-1
Park Stands
Refer to Figure 1-1 :
Park stands (#1) should be rotated down and locked to
support the grapple upright during assembly and when
storing the grapple. Park stands should always be rotated
up while grapple is attached to a tractor.
Rotate Park Stands Down
1. Press and hold locking lever (#2) to unlock left-hand
park stand (#1) from slot “A”.
2. Continue to hold locking lever (#2) while rotating park
stand down until locking lever aligns with slot “B”.
3. Release locking lever in slot “B” to secure park stand
in the rotated down position.
4. Repeat steps 1 to 3 for the right-hand park stand.
Rotate Park Stands Up
1. Press and hold locking lever (#2) to unlock left-hand
park stand (#1) from locking slot “B”.
2. Continue to hold locking lever (#2) and rotate park
stand up until locking lever aligns with locking
slot “A”.
3. Release locking lever in slot “A” to secure park stand
in the rotated up position.
4. Repeat steps 1 to 3 for the right-hand park stand.
37409
IMPORTANT: To protect park stands from damage,
always lock them in the up position while the
attachment is hitched to a power machine.
Customer Supplied Hydraulic Components
Figure 1-2
Optional/Customer Hydraulic Hoses
Refer to Figure 1-2:
1. Attach optional/customer supplied adapter fittings
and quick disconnect couplers to one end of both
optional/customer hydraulic hoses and tighten.
2. If customer supplies the hydraulic hoses, consult the
customer’s tractor Operator’s Manual to determine
which remote outlet is under pressure when pulling
back on tractor control lever.
•
Attach hydraulic hose connected to tee (#2) to the
outlet under presser to open the grapple claw.
•
Attach hydraulic hose connected to tee (#1) to the
remaining remote outlet to close the grapple claw.
3. Attach opposite end of optional/customer supplied
hydraulic hoses to tees (#1 & #2) and tighten.
37451
NOTE:
Land Pride offers optional “Hydraulic Hose
Kits” for connecting adapter fittings (#1 & #2) at the
grapple to Land Pride’s optional “Third Function
Valve Kits”. See “Optional Hose Kits” and
“Optional Third Function Valve Kits”
on page 15.
If Land Pride’s optional Third Functions Valve Kits
with optional Hydraulic Hose Kits are not purchased,
customer is to supply hydraulic hoses, fabric sleeves,
elbows, adapters, and quick connect couplers
between tractor/loader couplers and adapter fittings
(#1 & #2) at the grapple as they can vary in quantity,
size, and length depending upon which machine the
grapple is attached.
NOTE:
Make sure customer supplied hoses and
fittings will connect to 3/4"-16 MJIC threaded ends of
tees (#1 & #2).
NOTE: Line (#1) leads to base end of hydraulic
cylinders and will close grapple claw when under
pressure. Line (#2) leads to rod end of hydraulic
cylinders and will open grapple claw when under
pressure.