Land Pride SC2560, Руководство оператора

Страница: 16 / 44

12
SC2560 & SC2572 Skid Steer Rotary Cutter 326-836M 1/15/21
Table of Contents
Section 1: Assembly & Set-up
Figure 1-1
Float Chain Assembly
Refer to Figure 1-1:
1. (Not Shown) Unbolt and remove shipping brace bars
extending from hitch plate to center of deck.
2. Attach clevis end (#1) of float chains (#4) to hitch
plate with 9/16" clevis pins (#2) and cotter pins (#3).
Bend cotter pin legs to keep them from falling out.
3. Install other end of float chains (#4) to deck with
1/2" clevis pins (#5) and 1/8" cotter pins (#6). Bend
cotter pin legs to keep them from falling out.
37923
SC2560 Motor and hose Assembly
Figure 1-2
SC2560 Motor And Hose Assembly
Your Skid Steer Rotary Cutter is factory supplied with one
of three motors mounted to the deck. Make sure you
check GPM rating on the hydraulic motor decal to verify if
it matches your Skid Steer’s GPM rating. Skip assembly
instructions below if the motor GPM rating matches your
Skid Steer.
See
“Motor and Hose Assemblies”
on page 26 to
properly select a motor that matches your Skid Steer.
Refer to Figure 1-2:
1. Remove fasteners (#1 & 2). Keep fasteners for
reassembly of new motor.
2. Remove existing motor and hose assembly (#3).
Clean old gasket (#4) from gearbox flange (#5).
3. Place new gasket (#4) onto gearbox flange (#5).
4. Gently lower new motor and hose assembly (#3)
onto gasket (#4) with hoses extending towards the
hitch plate.
5. Secure hydraulic motor assembly with the four
existing 1/2"-13 x 2 1/4" lg. GR 5 hex head bolts (#1),
and 1/2"-13 hex flange lock nuts (#2). Tighten nuts to
the correct torque. See
“Torque Values Chart for
Common Bolt Sizes” on page 37.
37924
Decal Location Stating
Motor GPM Rating