Section 2: Set-Up of Options
11/27/18
10
3. Screw 87" long hydraulic hose (#5) into elbow (#4)
located at the cylinder rod end and tighten.
4. Thread adapter fittings (#7) to the other end of the
hydraulic hoses and tighten. (Customer to supply
quick disconnect hydraulic couplings.)
5. Attach hydraulic cylinder to the lugs located on the
left side of the Rear Blade with clevis pins (#1). Make
sure hydraulic ports are positioned on top and the
cylinder base in positioned to the front as shown.
6. Secure clevis pins with hair pin cotters (#2).
7.
Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to tractor's
hydraulic system.
Hydraulic Blade Offsetting, Angling and Tilt
Figure 2-1
25532
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.
Customer to supply
Quick Disconnect
Couplings.
Section 2: Set-Up of Options
Blade Offset Cylinder
Refer to Figure 2-1:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
1.
Position hydraulic cylinder (#3) with ports on top as
shown. Select two 90 degree elbows (#4) and install
them into the cylinder ports as shown. Tighten as
needed.
2. Screw 78" long hydraulic hose (#6) onto elbow (#4) at
the cylinder base and tighten.
IMPORTANT:
Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
