Land Pride RCM4610, Руководство оператора

Страница: 11 / 28

Section 1: Assembly and Set-Up
Table of Contents
RCM4610, CA0548 & CA0556 Core Aerators 325-108M 12/11/18
7
CA0540 Rotor Shaft Assembly
These instructions are for the 40" Aerator. See “CA0548
Rotor Shaft Assembly” on page 8 for 48" Aerator and
“CA0556 Rotor Shaft Assembly” on page 9 for 56"
Aerator.
Refer to Figure 1-4:
1. Turn hitch and weight tray upside down and orient as
shown. Position end panel (#1A) on the left end of the
weight tray to begin assembly of the rotor shaft.
2. Insert rotor shaft (#5) in end panel (#1A)
3. Install 1" flat washer (#6A), gang assembly (#2A),
1" flat washer (#6), spacer (#4), and second flat
washer (#6) on rotor shaft (#5).
IMPORTANT: Make sure all gang assemblies (#2)
are installed on rotor shaft (#5) with the open side of
the spoons facing forward in rotation as shown.
4. Install gang assembly (#2B), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
5. Install gang assembly (#2C), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
6. Install gang assembly (#2D), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
7. Install gang assembly (#2E) and 1" flat washer (#6B)
on the rotor shaft.
8. Install end panel (#1B) on the right end of the rotor
shaft (#5).
9. For continued instructions, skip to “Weight Tray &
Rotor Assembly” on page 10.
CA0540 Rotor Shaft Assembly
Figure 1-4
30015
Direction of
Rotation