Land Pride RCG3715, Руководство оператора

Страница: 58 / 66

Section 5: Maintenance & Lubrication
RC(M)3715 & RCG(M)3715 Rotary Cutters 334-114M 1/26/21
54
Table of Contents
Accessing CV Driveline Joints
Refer to Figure 5-14 on page 53:
There are two ways the constant velocity driveline joints
shown in Figure 5-14 can be accessed for lubrication.
One is through holes in the driveline shield and the other
is to slide the shields back to expose the grease zerks.
Lubrication Through Access Holes
1.
Refer to Figure 5-15:
Rotate driveline shield until
holes in shield align with grease zerks in CV joint.
2. Apply proper amount and type of lubrication. Refer to
“CV Main Driveline Joints” on page 53 for
quantities and type of lubrication.
3. Refer to Figure 5-16: Rotate driveline shield 180
o
until holes on opposite side of shield aligns with
remaining grease zerks in CV joint.
4. Repeat step 2 above on any grease zerks that were
not greased in step 2.
5. Steps 1-2 can be repeated to lubricate universal joint
on opposite end of driveline. (Opposite end of
driveline has only one grease zerk.)
Lubrication By Sliding Driveline Shields Back
1.
Refer to Figure 5-17:
With a flat bladed screwdriver
or similar tool, pry top of red locking tab up.
2.
Refer to Figure 5-18:
Rotate white locking ring fully
counterclockwise to the position shown.
3.
Refer to Figure 5-19:
Pull back on driveline shielding
until CV joint is exposed.
4. Apply proper amount and type of lubrication. Refer to
“CV Main Driveline Joints” on page 53 for
quantities and type of lubrication.
5. Slide driveline shield back to its operating position.
6.
Refer to Figure 5-17:
Rotate white locking ring
clockwise and press locking tab down until it snaps in
place as shown.
7. Steps 1-6 can be repeated to lubricate universal joint
on opposite end of driveline.
Lubrication Through Three Holes In Driveline Shield
Figure 5-15
Lubrication Through Two Holes In Driveline Shield
Figure 5-16
Locked Driveline Shield
Figure 5-17
Rotate Driveline Shield to Align
3-Holes in Shield With Grease Zerks
33992
Rotate Driveline Shield to Align
2-Holes in Shield With Grease Zerks
33993
Red Locking Tab
Snapped Down
Into Position
White Locking Ring
Positioned On Right Side
of Red Locking Tab
33994