Land Pride RCG3715, Руководство оператора

Страница: 25 / 66

Section 1: Assembly & Set-up
RC(M)3715 & RCG(M)3715 Rotary Cutters 334-114M 1/26/21
21
Table of Contents
Fold Lock Lugs Set Up
Refer to Figure 1-18:
If your cutter comes equipped with dual-action fold
cylinder set up, the fold lock lug plates (#15) do not need
to be flipped around. See Figure 1-19 .
If your cutter comes equipped with single-action fold
cylinder set up, perform the following steps to flip the four
fold lug plates around. See
Figure 1-20
.
1. With the wings down and on a level surface, remove
all 5/8" hex nuts (#1), lock washers (#2), flat washers
(#3) and 5/8"-11x1 3/4" bolts (#4) from both wing
decks. Set hardware aside for re-use.
2. On both wing decks, flip the fold lock lugs (#5) length
wise as shown.
3. Re-install 5/8" hex nuts (#1), lock washers (#2), flat
washers (#3) and 5/8"-11x1 3/4" bolts (#4). Hand
tighten nuts (#1).
4. Return to and start the tractor. Raise the wings and
shut down the tractor without relieving hydraulics.
5. Insert transport pins as shown in “Figure 1-16” .
6. Tighten all nuts (#1) on left and right hand wing decks
to correct torque.
Fold Lock Lugs Set Up For Dual Acting Cylinders
Figure 1-19
Fold Lock Lugs Set Up For Single Acting Cylinders
Figure 1-20
70545
70546
Fold Lock Lugs
Figure 1-18
70544