Land Pride RCG3715, Руководство оператора

Страница: 24 / 66

Section 1: Assembly & Set-up
RC(M)3715 & RCG(M)3715 Rotary Cutters 334-114M 1/26/21
20
Table of Contents
Wing Axle - Turnbuckle
Figure 1-15
Wing Axle Turnbuckle Set-up
Refer to Figure 1-15:
1. Park tractor and cutter on a level surface.
2. Shut tractor down properly before dismounting. Refer
to
“Tractor Shutdown Procedure”
on page 15.
3. Loosen jam nut (#2) on turnbuckle (#1) and adjust
until center of ball swivels are approximately 10 1/2"
apart. Do not tighten jam nut. Final adjustment will be
made later when leveling wing decks.
4. Repeat step 3 for the left wing axle.
Unfold Wings
DANGER
!
To avoid serious injury or death:
•
Keep everyone out of the area where the wing decks will
unfold. One of the wing decks can fall suddenly.
•
Do not walk, stand, or allow anyone else in the area where
a raised wing will fall unless the wing is securely locked in
the raised position with its transport lock..
Refer to Figure 1-16:
1. Park tractor and cutter on a level surface.
2. Release any tension on transport lock pins (#2) by
raising both wings up slightly.
3. Without relieving hydraulic pressure, shut tractor
down properly before dismounting. Refer to “Tractor
Shutdown Procedure”
on page 15.
70499
NOTE:
The cutter is shipped with turnbuckles
attached and drawn all the way in as shown in
Figure 1-15
.
4. Remove hairpin cotter (#1) from both the left and right
transport pins (#2).
5. Pull transport pins (#2) from lock holes (#3) on both
wings as shown.
Refer to Figure 1-17:
6. Store transport pins (#2) in storage holes (#3) as
shown and secure with hairpin cotters (#1).
7. Return to the tractor, staying clear of unpinned wings.
a. For cutters equipped with single-action fold
cylinders, restart tractor and place tractor control
lever for wing cylinders to float position. Return to
the cutter, staying clear of unpinned wings and
carefully position yourself on the center deck.
Manually push on the right wing until it starts to fall
on its own. The wing should fall slowly as the
hydraulic line is orificed to control the fall. If it does
not fall on its own, then continue lowering the wing
with tractor hydraulics. Repeat for left wing.
b. For cutters equipped with dual-action fold
cylinders, restart tractor and lower both left and
right wings with tractor hydraulic control lever until
both wings are on the ground.
Transport Pin
Figure 1-16
Transport Pin, Storage Position
Figure 1-17
70507
70508