24
Section 2: Optional Equipment Set-Up
RCF3684 Rotary Cutters 326-412M
11/13/18
Shredder/Fixed Blades & Baffle Kits
The shredder blades (#3) and stationary knives (#1 & #2)
for the RCF3660 & RCF3672 shredder kits are ideal for
cutting residue into smaller pieces.
Part Number & Description
326-610A
RCF3684 SHREDDER KIT
Assembly Instructions
The shredder blades, fixed blades, and baffles are
assembled at the factory if purchased with the Rotary
Cutter. If purchased later, the shredder blades, fixed
blades, and baffles will require assemble. The following
safety precautions should be adhered during assembly.
DANGER
!
To avoid serious injury or death:
•
Always disconnect driveline from the tractor before
servicing the drivetrain and components powered by the
drivetrain. A person can become entangled in the drivetrain
if the tractor is started and the power take-off is engaged.
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
1.
Raise wings fully up and lock into position with
transport locks.
2. Raise deck fully up and place support jacks under
the four corners of the center deck. Lower center
deck onto the support jacks.
3. Place tractor gear selector in park and/or set brakes,
shut engine off and remove ignition key.
4. Disconnect main driveline from the tractor’s power
take-off shaft.
Removal of Existing Blade Carriers
1.
Remove cotter pin (#4), slotted hex nut (#3), flat
washer (#2), and blade carrier assembly (#1) from
the gearbox spindle.
2. Keep removed hardware (#2, #3 & #4) for assembly
of shredder blades. Store blade assembly (#1) in a
clean dry location. Inside storage is best.
Removal of Existing Blade Carrier Assemblies
Figure 2-6
35518
Shredder Blades and Fixed Blades
Figure 2-5
35515
