Land Pride RC4615, Руководство оператора

Страница: 25 / 68

Section 1: Assembly & Set-up
Table of Contents
8/22/23 RC4615 & RCM4615 Rotary Cutters 331-644M
21
Transport Bar, Locked Position
Figure 1-14
Unfold Wings
DANGER
!
To avoid serious injury or death:
Keep everyone out of the area where the wing decks will
unfold. One of the wing decks can fall suddenly.
Refer to Figure 1-14:
1. Park tractor and cutter on a level surface.
2. Raise both wings up to release any tension on
transport lock bars (#3).
3. Shut tractor down properly before dismounting. Refer
to
“Tractor Shutdown Procedure” on page 16.
4. Remove hairpin clip (#1) from both the left and right
cylinder pins (#4).
Refer to Figure 1-15:
5. Rotate end of transport lock bar (#3) to the storage
pin (#2) as shown in Figure 3-2 on page 35. Secure
with hairpin clips (#1).
6. Restart tractor and lower both left and right wings
with tractor hydraulic control lever until both wings
are on the ground.
1
4
3
27921
Transport Bar, Storage Position
Figure 1-15
Driveline Installation
DANGER
!
To avoid serious injury or death:
•
Do not engage power take-off while connecting or
disconnecting the driveline, or while someone is standing
near the driveline. A person’s body and/or clothing can
become entangled in the driveline.
•
Make certain driveline yokes are securely fastened at each
end. A loose yoke can work free allowing the driveline to
rotate uncontrollably.
WARNING
!
To avoid serious injury or death:
Some tractors are equipped with two power take-off speeds.
Be certain your tractor’s power take-off shaft is set-up to
operate the implement at its rated power take-off speed. Do
not exceed implement’s rated power take-off speed. Excessive
speed can damage drive/driven components, and increase the
risk of a thrown object hazard. RC models are rated for 540
rpm and RCM models are rated for 1000 rpm.
27923
3
2
1
4