Land Pride RBT6010, Руководство оператора

Страница: 13 / 34

Section 1: Assembly & Set-Up
RBT6010 & RBT6012 Rear Blades 301-360M 11/27/18
9
Table of Contents
Blade Offset Cylinder
Refer to Figure 1-2:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
1. Attach hydraulic cylinder (#5) to lugs (#1 & #2) with
clevis pins (#4). Make sure cylinder ports are on top
and cylinder base is mounted to lug (#1).
2. Secure clevis pins with cotter pins (#3). Bend one or
more legs on the pins to keep them from falling out.
IMPORTANT: Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
3. Remove shipping port plugs from cylinder ports.
4. Screw adapter fittings (#6) to the two cylinder ports
with O-rings facing the ports. Tighten fittings.
5. Screw remaining two adapter fittings (#6) to one end
on each of the two 99" long hydraulic hoses (#8 & #9)
with O-rings facing away and tighten.
6. Attach customer supplied hydraulic couplings (#7)
to adapter fittings (#6) on hoses (#8 & #9) & tighten.
7. Screw the other end of the hydraulic hoses to adapter
fittings (#6) on the cylinder and tighten.
8. Route hydraulic hoses through bracket “A” and store
hose ends in storage slots. If hitched to a tractor,
connect the hoses to the tractor’s hydraulic system.
Hydraulic Blade Offsetting
Figure 1-2
27865
Use storage slots in hitch
frame for storing end of
hydraulic hoses while parked.
DO NOT REMOVE SHIPPING BLOCK (#10) FROM
MOLDBOARD CARRIER UNTIL AFTER ALL
HYDRAULIC CYLINDERS HAVE BEEN INSTALLED.