Land Pride RBT6010, Руководство оператора

Страница: 14 / 34

Section 1: Assembly & Set-Up
RBT6010 & RBT6012 Rear Blades 301-360M 11/27/18
10
Table of Contents
Blade Angle Cylinder
Refer to Figure 1-3:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
1. Attach hydraulic cylinder (#5) to lugs (#1 & #2) with
clevis pins (#4). Make sure cylinder ports are on top
and cylinder base is mounted to lug (#1).
2. Secure clevis pins with cotter pins (#3). Bend one or
more legs on the pins to keep them from falling out.
3. Remove shipping port plugs from cylinder ports.
4. Screw adapter fittings (#6) to the two cylinder ports
with O-rings facing the ports. Tighten fittings.
IMPORTANT: Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
5. Screw remaining two adapter fittings (#6) to one end
on each of the two 144" lg. hydraulic hoses (#8 & #9)
with O-rings facing away and tighten.
6. Attach customer supplied hydraulic couplings (#7)
to adapter fittings (#6) on hoses (#8 & #9) & tighten.
7. Screw the other end of the hydraulic hoses to adapter
fittings (#6) on the cylinder and tighten.
8. Route hydraulic hoses through brackets “A” & “B” and
store hose ends in storage slots. If hitched to a
tractor, connect hoses to the tractor’s hydraulic
system.
Hydraulic Blade Angling
Figure 1-3
27866
DO NOT REMOVE SHIPPING BLOCK (#10) FROM
MOLDBOARD CARRIER UNTIL AFTER ALL
HYDRAULIC CYLINDERS HAVE BEEN INSTALLED.
Use storage slots in hitch
frame for storing end of
hydraulic hoses while parked.