Land Pride RB3772, Руководство оператора

Страница: 13 / 28

Section 2: Accessory Equipment Set-Up
Table of Contents
11/27/18 RB3772, RB3784, & RB3796 Rear Blades 301-457M
9
Hydraulic Blade Angling Accessory Kit
Figure 2-1
35454
Section 2: Accessory Equipment Set-Up
Hydraulic Angling Kit
Refer to Figure 2-1:
This Hydraulic Angling Kit can be easily attached to the
RB37 Series Rear Blades to make blade angling easy
with tractor hydraulic control lever.
Kit Bundle
301-404A . . . . . . . . . . . . . . . . KIT, RB37 HYDRAULIC ANGLE
DANGER
!
To avoid serious injury or death:
Do not remove hardware securing blade pivot cap without
supporting underside of blade. The blade will fall if not
supported.
1. Support rear blade by lowering unit to the ground. If
unhooked from a tractor, make sure parking stand is
rotated down and secured.
2. Skip to step 3 is angling plate (#4) is installed. If not,
continue with steps a & b below:
a. Remove bolt (#11), retainer cap (#3), and drive
pivot cap (#6). Keep bolt (#11) and retainer
cap (#3) for reuse. Store drive pivot cap (#6).
b. Attach hydraulic angling plate (#4) to pivot
shaft (#5) with pivot cap (#3) and 3/4"-10 GR5
bolt (#11). Do not tighten bolt (#11) at this time.
3. If not loose, loosen bolt (#11) and insert 1"-8 x 7 1/2"
long GR5 bolt (#10) through angle plate (#4) and
pivot plate (#8). Secure bolt (#10) with hex flange top
locknut (#12) and tighten to the correct torque.
4. Supplied with hydraulic cylinder (#15) are two clevis
pins (#2A & #2B) and four cotter pins (#1A & #2A).
Store only clevis pin (#2B) with pivot cap (#6).
5. Position hydraulic cylinder (#15) with ports on top
and cylinder base facing forward. Attach rod end of
hydraulic cylinder to angling plate (#4) with 6 1/4"
long clevis pin (#14), cylinder spacer (#7), and clevis
pin (#14). Secure clevis pin with cotter pins (#1B).
Bend cotter pin legs around clevis pin (#14).
6. Remove port plugs from hydraulic cylinder and pull
hydraulic cylinder (#15) forward until hole in base end
is in alignment with front mounting lug hole.
7. Secure hydraulic cylinder to front mounting lug with
clevis pin (#2A) and cotter pins (#1A). Bend cotter pin
legs around clevis pin (#2A).
8. Screw elbows (#9A & #9B) into cylinder ports and
tighten with elbows facing forward.
9. Attach adapter fittings (#16) to one end of hydraulic
hoses (#18 & #19) and tighten.
10. Quick disconnect couplings are not provided. Attach
customer supplied quick disconnect couplings (#17)
to adapter fittings (#16) and tighten.
11. Tighten short hydraulic hose (#18) to elbow (#9A).
12. Tighten long hydraulic hose (#19) to elbow (#9B).
13. Remove bent pin (#13) and store with pivot cap (#6).
IMPORTANT: Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount. (#8).
IMPORTANT: 13The bent pin must be removed
before angling the blade with hydraulics. Not
removing it can damage the Rear Blade.