Land Pride Powered Rakes PR1660, Руководство оператора

Страница: 16 / 38

Section 1: Assembly & Set-Up
Table of Contents
11/6/18 PR1660, PR1672 & PR1690 Powered Rakes 314-216M
12
5. Pull back on inner yoke pull collar (#4) and push inner
driveline yoke onto the rake gearbox shaft. Release
pull collar and continue to push driveline yoke
forward until pull collar locks in place.
6. Pull back on outer yoke pull collar (#6) and push outer
driveline yoke onto the tractor power take-off shaft.
Release pull collar and continue to push driveline
yoke forward until pull collar locks in place.
7. If driveline (#3) will not collapse enough to start
driveline onto power take-off shaft, skip to
“Check
Driveline Collapsible Length” on page 12.
8. Driveline (#3) should now be moved back and forth at
both ends to ensure yokes are secured to tractor and
rake power shafts. Reattach any end that is loose.
Check Driveline Collapsible Length
Refer to Figure 1-2:
1. Make sure driveline is properly installed and level
before checking driveline collapsible length. (Refer to
“Driveline Installation” instructions on page 11 if
needed.)
2. With driveline level, measure 1" ( “B” dimension)
back from universal joint shield to end of outer
driveline shield as shown in Figure 1-2 on page 12. If
measurement is less than 1", then shorten driveline
using instructions provided on this page.
IMPORTANT: A driveline that is too long can bottom
out causing structural damage to the tractor and
implement. Always check driveline minimum length
during initial setup, when connecting to a different
tractor, and when alternating between using a quick
hitch and a standard 3-point hitch. More than one
driveline may be required to fit all applications.
Driveline Shortening
Figure 1-2
Shorten Driveline Length
Refer to Figure 1-2:
1. Un-hook driveline from tractor power take-off shaft.
2. Pull outer driveline apart from inner driveline and
reattach outer driveline to tractor power take-off shaft.
3. Pull on inner and outer drivelines to be sure universal
joints are properly secured.
4. Hold inner and outer drivelines parallel to each other:
a. Measure 1" ( “B” dimension) back from outer
driveline universal joint shield and make a mark at
this location on the inner driveline shield.
b. Measure 1" ( “B” dimension) back from the inner
driveline universal joint shield and make a mark at
this location on the outer driveline shield.
5. Remove driveline from tractor and gearbox shafts.
6. Measure from end of inner shield to scribed mark
( “X” dimension). Cut off inner shield at the mark. Cut
same amount off the inner shaft ( “X1” dimension).
7. Measure from end of outer shield to scribed mark
(
“Y” dimension). Cut off outer shield at the mark. Cut
same amount off the outer shaft ( “Y1” dimension).
8. Remove all burrs and cuttings.
9. Apply multi-purpose grease to the inside of the outer
shaft and reassemble driveline.
10. Attach driveline to splitter gearbox input shaft and
tractor power take-off shaft.
11. Start tractor and raise rake just enough to remove
support blocks.
12. Continue with “Identify Driveline Maximum
Allowable Length” on page 13.
30398