Land Pride GR1525, Руководство оператора

Страница: 22 / 44

Section 1: Assembly & Set-up
GR1525 Stump Grinder 328-167M 3/17/20
18
Table of Contents
then skip to “Check Driveline Maximum Length” on
this page. Otherwise continue with step 8.
Driveline Shortening
Figure 1-10
Refer to Figure 1-10:
8. If dimension “A” was less than 1" (2.5 cm), shorten
driveline as follows:
a. Measure 1" (2.5 cm) (
“B1” dimension) back from
outer driveline shield and make a mark at this
location on the inner driveline shield.
b. Measure 1" (2.5 cm) ( “B2” dimension) back from
the inner driveline shield and make a mark at this
location on the outer driveline shield.
9. Remove outer driveline from the tractor power take-
off shaft and inner driveline from the implement’s
gearbox shaft.
10. Cut off non-yoke end of inner driveline as follows:
a. Measure from end of inner shield to scribed mark
( “X” dimension) and record.
b. Cut off inner shield at the mark. Cut same amount
off the inner shaft ( “X1” dimension).
11. Cut off non-yoke end of outer driveline as follows:
a. Measure from end of outer shield to scribed mark
( “Y” dimension) and record.
b. Cut off outer shield at the mark. Cut same amount
off the outer shaft ( “Y1” dimension).
12. Remove all burrs and cuttings.
13. Continue with
“Check Driveline Maximum Length”
on this page.
22311
30398
22311
30398
Driveline Maximum Extended Length
Figure 1-11
Check Driveline Maximum Length
Refer to Figure 1-11:
The driveline maximum allowable length must, when fully
extended, have a minimum overlap of profile tubes by not
less than 1/2 the free length with both inner and outer
profile tubes being of equal length.
1. Apply multi-purpose grease to the inside of the outer
shaft and reassemble the driveline.
2. Assemble the two driveline profiles together with just
1/2 overlapping of the profile tubes as shown. Once
assembled, measure and record maximum allowable
length here. ________
3. Reattach driveline to the tractor power take-off shaft
and gearbox input shaft. Refer to “Driveline Hook-
Up”
on page 17.
4. Continue with “Hydraulic Hose Hook-up” on page
19.
24804
Outer Shielding has been removed for clarity.