Section 2: Operating Procedures
BB4596, BB4510, & BB4512 Pull Type Drag Scraper 306-096M
11/28/18
17
Tractor Hook-up
Figure 2-1
37298
70162
Tractor Hook-up
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking
implement. Keep people and animals away while backing-up
to implement or pulling away from implement. Do not operate
hydraulic controls while a person or animal is directly behind
the power machine or near the implement.
WARNING
!
To avoid serious injury or death:
•
Make sure the hitch pin is secured to the tractor drawbar
with a keeper clip and implement safety chain is attached to
the tractor to help protect against the implement becoming
unhooked and out of control while traveling.
•
Always shut tractor down using “Tractor Shutdown
Procedure” provided in this manual before allowing anyone
including the operator to hook-up and unhook implement.
1.
Start tractor and raise lower 3-point arms fully up.
Carefully back tractor within close proximity of hitch
clevis (#5).
2. Shut tractor down before dismounting. Refer to
3. Attach the pair of hydraulic hoses (#3) coming from
the lift cylinder to the tractor’s duplex outlet controlled
by the hydraulic lever located closest to the operator.
4. If optional tilt axle cylinder is included, attach the pair
of hydraulic hoses (#4) connected to the tilt cylinder
to a second duplex outlet.
5. Return to the tractor seat, start tractor, and operate
control lever to raise rear wheels up until scraper
hitch (#5) aligns with tractor drawbar.
IMPORTANT:
Only use park jack (#9) if storing the
Drag Scraper in transport position (cutting edge off
the ground). Instructions below are for hooking-up
the Drag Scraper with cutting edge on the ground.
6. Back tractor up to the hitch until holes in the scraper
hitch align with tractor drawbar hitch hole.
7.
Shut tractor down before dismounting. Refer to
8. Attach scraper hitch (#5) to the tractor with hitch
pin (#6). Secure hitch pin with hitch pin keeper (#7).
9. Attach safety chain (#8) to the tractor frame. Make
sure safety chain is secured.
Tractor 7-Pin Electrical Outlet
Figure 2-2
Hook-up LED Lights
Optional with BB4596 & BB4510. Standard with BB4512.
The lead wiring harness (#13) is equipped with a 7-way
round pin connector for connecting to the tractor’s 7-pin
electrical outlet shown in Figure 2-2.
1.
Route lead wire harness (#13) through spring hose
loop (#11) and tongue hose support loop (#12).
2. Connect lead wire harness (#13) to the tractor’s
7-way round pin receiver.
3. It is best to have a second person verify the lights are
operating. Start tractor and operate lights as follows:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber light are
blinking on and off.
IMPORTANT:
Customer to supply hitch pin (#6) and
hitch pin keeper (#7). A hammer strap above the
drawbar should be used when hooking-up the swivel
ball hitch. See
