Land Pride BB4596, Руководство оператора

Страница: 19 / 32

Section 1: Assembly & Set-up
BB4596, BB4510, & BB4512 Pull Type Drag Scraper 306-096M 11/28/18
15
Table of Contents
9. Attach connector (#3A) to connector (#3B) on lead
wire harness (#4).
10. Route lead wire harness (#4) through spring hose
loop (#12) and tongue hose loop (#13).
11. Connect wire harness (#4) to the tractor’s 7-way
round pin receiver.
12. Start tractor and operate lights to verify hook-up is
operating properly:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber light are
blinking on and off.
13. If the lights did not operate properly, recheck hook-up
of wire harnesses (#1 & #2). Make necessary
changes to the harnesses and repeat step 12 above.
14. Recheck wire harness routing to make sure wires will
not pinch as scraper is raised and lowered.
15. With the two longer cable ties (#10), tie enhance
module (#3) to hydraulic hoses between spring hose
loop (#12) and lift cylinder.
16. Add cable ties (#11) to wire harnesses (#1, #2, & #4)
as needed along the back of rear blade panel and
along the hydraulic hoses.
17. Draw all cable ties up tight to secure wire harness
(#1 & #2) and enhance module (#3).