Land Pride 380-289A, Руководство по установке

Страница: 3 / 14

3
11/11/20 BX Third Function Valve Kit #380-289A & #380-339A Installation Instructions Manual No. 380-304M
Assembly Instructions
Remove Hose (#43)
Figure 3
Connect to Power Beyond Port
Refer to Figure 3, Figure 4, & Figure 5:
1. Place chocks in front and back of tractor’s left rear
wheel.
2. Loosen lug nuts on right rear wheel. Do not remove
lug nuts at this time.
3. Jack right rear wheel off the ground and place a jack
stand under the right rear wheel axle.
4. Lower right rear axle onto the jack stand. The wheel
should still be slightly off the ground. Make sure jack
stand is secure and will not slip out from under the
tractor axle.
5. Remove lug nuts and right rear wheel.
Refer to Figure 3:
6. Locate and remove the hydraulic line (#43) that
connects power beyond port on the loader valve to
power beyond port (P1). The outlet block is directly
behind the right rear tractor tire.
Refer to Figure 1 on page 2 & Figure 4:
7. Connect elbow fitting (#10) to the fitting on the power
beyond port (P1) where the hydraulic line was
removed in step 6.
8. Connect free end of hydraulic hose (#7B) to elbow
fitting (#10).
74898
43
P1
IMPORTANT:
Land Pride recommends that your
dealer connect hydraulic hoses (#7A & #7B) to your
tractor’s power beyond port (P1) and loader valve
fitting (T1). Improper hook-up could cause damage
to your tractor.
IMPORTANT:
DO NOT connect hydraulic hoses
(#7A & #7B) to the loader valve fitting (T1) and
power beyond port (P1) if the outer block feeds
equipment mounted on the back of the tractor such
as a backhoe. The instructions below do not apply in
this situation. Have your nearest dealer hook-up
these hoses. Improper hook-up can damage your
Install Hose (7B)
Figure 4
Install Hose (7A)
Figure 5
Refer to Figure 1 on page 2 & Figure 5:
9. Connect free end of the hydraulic hose (#7A) to the
fitting (#42) on the loader valve where the hydraulic
line was removed in step 6.
10. Secure hoses (#7A & #7B) to the underside of the
tractor with cable ties (#1).
11. Replace right rear wheel and screw lug nuts on until
snug.
12. Jack axle up and remove jack stand.
13. Lower tractor down and tighten lug nuts in a
crisscross pattern. Refer to tractor Operator’s Manual
for proper torque value.
14. Remove chocks.
15. Check tractor hydraulic fluid level. If low, add
recommended hydraulic fluid. Refer to your tractor
Operator’s Manual for recommended hydraulic fluid
and procedure for checking hydraulic fluid level.
74898
7B
10
74898
7A
42