LANCOM 3850 UMTS
Chapter 2: Installation
22
EN
The power LED blinks alternately in red/green until a configuration
password has been set. Without a configuration password, the confi-
guration data in the LANCOM are unprotected. Normally you would
set a configuration password during the basic configuration (instruc-
tions in the following chapter). Information about setting a configu-
ration password at a later time is available in the section 'The Security
Wizard'.
���
Online
The online LED displays the general status of all WAN interfaces:
The power LED is blinking and no connection can be
made?
If the power LED blinks red and no WAN connections can be
established, there is no cause for concern. This merely means
that a pre-set charge or time limit has been reached.
There are three ways to remove the lock:
Reset the toll protection.
Increase the limit.
Deactivate the lock completely (set limit to '0').
LANmonitor shows you when a charge or time limit has been reached. To reset the toll protec-
tion, activate the context menu (right-mouse click)
Reset charge and time limits
. The charge
settings are defined in LANconfig under
Management
Costs
(these settings are only avai-
lable if the 'Complete configuration display' is activated under
Tools
Options
).
With WEBconfig, resetting the toll protection and all parameters are found under
Expert con-
figuration
Setup
Charges
.
Power
P
ower
Signal that a
charge or time
limit has been
reached
Off
No active connection
Green
Flashing
Opening the first connection
Green
Inverse flashing
Opening an additional connection
Green
On (perma-
nently)
At least one connection is established
