Lancom 821+, Руководство пользователя

Страница: 23 / 76

LANCOM 821+ – LANCOM 1711+ VPN – LANCOM 1721 VPN
Chapter 2: Installation
22
EN
Boot only: With a suitable setting, the behavior of the reset button can
be controlled; the button is then ignored or a press of the button
prompts a re-start only, however long it is held down.
Reset-or-boot (standard setting): Press the button briefly to re-start
the device. Pressing the button for 5 seconds or longer restarts the
device and resets the configuration to its factory settings. All LEDs on
the device light up continuously. Once the switch is released the
device will restart with the restored factory settings.

After resetting, the device starts completely unconfigured and all set-
tings are lost. If possible be sure to backup the current device config-
uration
before resetting.
2.4 Hardware installation
The installation of the LANCOM Router base station takes place in the follow-
ing steps:
LAN – connect the LANCOM Router to your LAN or to an individual PC.
For that purpose, plug the included network cable (green plugs) into the
LAN connector of the device
and the other end into a free network
connecting socket of your local network, into a free socket of a hub/switch
or into the network socket of an individual PC.
The LAN connector identifies automatically the transfer rate (10/100
Mbps) of the connected network device (autosensing). A parallel connec-
tion of devices with different speeds and types is possible.

You should never have more than one unconfigured LANCOM Router
in a network segment at any given time. All unconfigured LANCOM
Router devices use the same IP address (with the final digits '254'),
which would result in an address conflict. To avoid problems, always
configure multiple LANCOM Router devices one at a time, immedi-
ately assigning each device a unique IP address (one that does not
end with '254').
821+/1721 only ADSL – connect the ADSL interface to the splitter using the supplied
ADSL connector cable (transparent plugs).
1711+ only DSL – connect the WAN interface to the DSL modem socket using the
supplied DSL connector cable (dark blue plugs).