LANCOM 1751 UMTS
Chapter 3: Basic configuration
34
EN
Enter the wireless parameters. Select a network name (SSID) and a radio
channel. Turn on if necessary the function for ’closed network’. Confirm
your choice with Next.
In the following 'Security settings' window, specify a password for confi-
guration access. Note that the password is case-sensitive and ensure that
it is sufficiently long (at least 6 characters).
You may specify whether the device may only be configured from the local
network or whether remote configuration via the WAN (i.e. a remote net-
work) is also permissible.
Please note that enabling this will also permit remote configuration
via the Internet. You should always make sure that the configuration
access is suitably protected, e.g. with a password.
In the next window, select your DSL provider from the list that is displayed.
Confirm your choice with Apply.
If you select 'My provider is not listed here,' you must enter the transfer
protocol used by your DSL provider manually in the next window. Confirm
your choice with Apply.
Connect charge protection can limit the cost of DSL connections to a pre-
determined amount if desired. Confirm your choice with Apply.
The basic setup wizard reports that all the necessary information has been
provided. You can end the wizard with Go on.
Entering the password in the web browser
When you are prompted for a user name and
password by your web browser when accessing
the device in the future, enter your personal
values to the corresponding fields. Please note
that the password is case-sensitive.
If you are using the common configuration
account, enter the corresponding password only.
Leave the user name field blank.
Entering the configuration password
110584_LC-1751-UMTS-MANUAL-EN.book Page 34 Tuesday, February 26, 2008 5:16 PM
