lancer 810 LX, Инструкция по установке и эксплуатации

Страница: 13 / 33

810-815 LX / INSTALLATION
NI_810-815_LX_PILOTE_ANG_A.doc 13
WATER CONNECTIONS
(DEMINERALIZED WATER TANK SUPPLY WITH PLINTH BASE STAND / 90 02010020)
COLD WATER :
A valve with a male threaded nozzle, 20/27 diameter, (3/4" hose thread) is
required.
Flow rate : 20 l/min (5.3 GPM) with a minimum pressure of 200 kPa (2 bar or
29 PSI) and maximum 600 kPa (6 bar or 87 PSI).
DEMINERALIZED, DISTILLED OR REVERSE OSMOSIS WATER :
The machine is fitted with a hose barb type fitting with an outside diameter of 20
mm (3/4 inch) on its base and the tank is installed 650 mm (26 inches) above
floor level on a support, preferably of type BRH as manufactured by LANCER.
Hose clamps should be used to make the connection to the hose barb fitting.
Flow rate: 20 l/min (5.3 GPM) under minimum pressure of 0 kPa (0 bar or 0
PSI) and maximum 28 kPa (0.28 bar or 4 PSI).
The waters intakes will have to be in waters intakes setting up area ( see drawing
next page ).
Remove the rear bodywork to accede to the connection support.
WATER CONNECTIONS
-1- COLD WATER
-2- DEMI. WATER