Lancaster PLATINUM LINE LES X Factor Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 20

PAGE 7
PLACING THE CITY SOFT PLUS INTO SERVICE
PLACING UNIT INTO SERVICE: Make sure inlet and outlet valves are to their closed positions. If using optional
bypass, place in bypass position. Turn on main water supply. Open a cold water faucet. This will clear the lines of any debris
(solder, pipe dope, etc.) that may be in the line. Let water run at tap for a couple of minutes, or until clear. Turn off faucet.
Manually add 1½ gallons of water to the brine tank.
•
Press and hold the REGEN button for approximately 5 seconds until the motor starts.
• Wait until display reads BACKWASH and numbers start counting down.
If using optional bypass SLOWLY turn bypass valve to DIAGNOSTIC position
(
See figure 3 on page 4
)
or slowly open inlet
valve to allow water to slowly enter the softener.
When water is flowing steadily to drain without the presence of air, momentarily press REGEN again. Display will read
REGEN DN . Momentarily press REGEN again. Display will read RINSE.
Open the outlet valve of the softener, or if using optional bypass place to NORMAL OPERATION MODE ( see figure 1 on
page 4 ).
Allow control to finish the RINSE cycle. It will then advance to the FILL position. The brine tank will now automatically fill with
the proper volume of water for the first regeneration.
Allow the control to automatically advance to the SOFTENING position.
Load the brine tank with salt. Solar Salt is recommended.
SANITIZING : Use 2 oz. of 5¼% household chlorine bleach for each cubic foot of resin. Pour bleach directly into the brine
well of the softener. Press and hold the REGEN button for 5 – 6 seconds until the motor starts running. Allow system to
complete the regeneration automatically. Check for other local and state codes which may also specify sanitation methods.
Current time of day needs to be entered during initial installation, and adjusted when daylight saving time begins or ends.
If an extended power outage occurs and depletes the on-board non-rechargeable coin cell battery, when power resumes
the time of day should be reset and battery replaced.
STEP 1
STEP 2
STEP 3
STEP 1 – Press
CLOCK
STEP 2 - Current Time (hour): Set the hour of the day using or buttons. AM/PM toggles
after 12. Press
NEXT
to go to Step 3.
STEP 3 - Current Time (minutes): Set the minutes of the day using or buttons. Press
NEXT to exit Set Time of Day. Press
REGEN
to return to previous step.
RETURN TO NORMAL MODE
SET TIME OF DAY