
VIII-10
February 2008
Legacy
VIII-11
February 2008
Legacy
sufficient for the flight duration. The oil level is checked thru the small door on
the upper right top side of the engine cowling. A minimum of 6 quarts should be
indicated before every flight.
Oil Changes
During the initial break-in the engine should be operated with a straight mineral
oil. The break-in is normally 25 to 50 hours during which time the oil consumption
should stabilize. Following this break- in period, the oil and filter should be changed
and an oil Ashless Dispersant Oil installed. If consumption has not stabilized at
the 25 to 50 hour point, continue the use of mineral oil.
The engine oil should be changed at a minimum of each 50 hour of flight time.
More often is recommended. The engine oil should be drained while the engine
is thoroughly warm and with the aircraft in a level position. The fllter should be
changed at each oil change and the element examined for its contents. If a ”spin-
on“ fllter is installed it should be cut open and the element examined. Sand type
material is indicative of inadequate air filtration and may warrant corrective action
ranging from more frequent changes to the installation of an improved filter system.
Metallic particles may vary from aluminum to steel to stainless steel. Following
the initial break-in period during which some metallic particles are normal almost
any amount there-after becomes cause for concern. If subsequent changes show
additional metallic particles, the source should be determined. The type can be
somewhat determined by separating by category, i.e. magnetic or not, steel or
aluminum, silicon (sand), etc.
Another method of determining the source is the use of spectral analysis of an oil
sample. These services are readily available by mail, and can provide you with a
running history of the contaminates from each of your oil changes.
BATTERY
The battery should be checked for electrolyte level at each 25 hour inspection and
serviced as necessary with distilled water. Do not overfill, nor should the battery be
serviced in a low or discharged condition. If the battery is low on charge, service
to cover the plates, charge to full, then service to full. Full is generally indicated
by a “service ring” within each cell of the battery about an inch from the top.
Excessive water consumption may be an indication of an improperly set voltage
regulator. The fully serviced and charged electrolyte should be checked for spe-
cific gravity.
Содержание Legacy
