Lanbe AS-3100L Series, Руководство пользователя

Страница: 11 / 11

11 / 11
1. The connecting wire must be plugged into the port from which it is pulled out.
2. Plug the mouse before the keyboard.
Note: The KVM control platform must be power on before PC.
Power On/Off and Reboot
If user needs to cut off the power of KVM control platform, please follow the steps before power on
again.
1.
Cut off the power supply of all computers.
Note:
1) The power wire of computer with keyboard power on function must be pulled out. Otherwise, the
KVM still receives the power signal from computer.
2) If the control unit uses the external power, please pull out external power.
2. After about 10 seconds, power on the KVM control platform.
3. After the KVM switch starts, power on the computers.
INTERFACE SELECTION
There are two ways to select: Hot key and OSD menu.
HOTKEY
The hotkey let the user control the connected computers by keyboard. Please check AUTO
SWITCH user manual.
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1)this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.