Lanaform Body Stim, Руководство пользователя

Страница: 6 / 112

EN
B. LCD screen
• For each part of the body, there are six stimulating functions (6 manual modes). For each of these functions, there are
4 different frequencies which work alternately. The frequencies can be observed by a change in the flashing arrows
(acceleration, deceleration).
• The mode indicated by the arrow is the unit’s current operating mode.
• Four automatic modes: each automatic mode is recommended by experts and is applicable to the corresponding
positions. Whichever automatic mode is selected, the appliance will work in this automatic operating mode and changes
to the modes and frequency will be indicated by the arrows. The automatic modes alternate the various manual modes
so as to best match the mode chosen.
• Schematic diagram of the human body.
• Application position for the operating mode (acupuncture point): indication detailing the correct position for this
operating mode.
• Predetermined time display. The time remaining will be shown on the display.
C. Use
1) Preparation before use
The
BODY STIM
operates with 3 AA batteries (not supplied). Before using your appliance, please place the batteries in
the correct position, at the back of the appliance.
Slide the cover of the battery compartment in the direction of the arrow and
insert the batteries respecting the plus and minus signs. Then close the cover. Your
appliance is ready for use.
Before switching on your
BODY STIM , first please place the electrodes in the
desired positions, then connect the electrode cable to your low frequency
stimulator.
Warning:
never apply the electrodes to the head or opposite each other (see
picture): i.e. do not place the two electrodes connected to each other on either
side of your body part. Never move the electrodes when appliance is in operation.
Switch it off by decreasing the intensity to “OFF”, only then should you remove the
electrodes to place them in another position. Strong sensations may be felt if this
instruction is not applied.
2) Operation
a. Apply the electrodes on the body parts you intend to build up as shown on the diagram.
b. Switch the
Body Stim
on by turning the Intensity/Supply button clockwise from the OFF position. The LCD screen will
start to operate. The appliance is now in the “Tapping” operating mode and the time is pre-set to 15 minutes, without
repetition.
c. Select your mode:
Press the manual mode button: you can choose between six manual modes, i.e. tapping, acupuncture, kneading,
application of suction pads, scratching and massage. To do this, press the manual mode button (button 6) until the
arrow is opposite the desired mode.
You can also press the automatic mode button to choose from among the four modes – i.e.: muscle development,
figure slimming, neck/shoulders and back/legs. Display the selection mode. The automatic mode selected will be
displayed on the screen. If no automatic mode is displayed, it means that you are in manual mode.
6