Lamtec ETAMATIC, Быстрая справка

Страница: 20 / 26

19
8 Appendix
NOTICE
In case of a fault message occuring which is not mentioned in this fault code list please refer
to the burner manufacturer or commissioner of the plant.
Fault
Code

No.
Restart according to Description
TRD EN676
741 0 0 Seal tightness check: Main Gas 1 open for too long.
742 0 0 Seal tightness check: Main Gas 2 leaky.
743 0 0 Flame monitoring: flame after-burn too long
744 0 0 Flame monitoring: flame on again
745 0 0 Programme check time exceeded.
747 0 0 Leak check: ventilating into boiler not allowed
750 0 0 Shut-down on faults via bus.
751 >88 3 No data transfer via the bus (time-out).
764 1 1 CO-Controller, internal fault no. -
889 0 0 Time interval between remote-fault-resets is too short .
904 1 1 Error in reference of firing rate
911 1 1 Error in reference, channel: 1
912 1 1 Error in reference, channel: 2
913 1 1 Error in reference, channel: 3
914 1 1 Error in reference, channel: 4
921 0 0 Relay driver self-test : output terminal 11 or 66 (ETAMATIC) faulty.
922 0 0 Relay driver self-test : output terminal 16 or 65 (ETAMATIC) faulty.
923 0 0 Relay driver self-test : output terminal 43 or 68 (ETAMATIC) faulty.
924 0 0 Relay driver self-test : output terminal 67 faulty
925 0 0 Relay driver self-test : output terminal 45 faulty.
926 0 0 Relay driver self-test : output terminal 68 or 61 (ETAMATIC) faulty.
927 0 0 Relay driver self-test : output terminal 36 (ETAMATIC K202) faulty.
929 0 0 Relay driver self-test : output terminal 76 faulty
930 0 0 Relay driver self-test : Output K203 defect.
931 0 0 Relay driver self-test : Output K201 defect.