Lampert PUK D3, Руководство по эксплуатации

Страница: 17 / 24

© Lampert Werktechnik GmbH 2017 16
8. CARE OF THE SYSTEM COMPONENTS
8.1 CARE OF WELDING DEVICE AND WELDING MICROSCOPE
Your PUK as well as the welding microscope require a
minimum
of maintenance under normal working
conditions . However, it is essential that a few points are
observed in order to guarantee the functionality and to
keep the spot welding device fully operational for years to
come.
•
Check the mains plug and cable as well as all welding
and connection cables regularly for damage.
•
Check that the moving parts of the handpiece move
easily.
•
If necessary, clean the electrode threaded assembly on
the handpiece, in order to ensure optimal contact with
the electrodes.
•
Clean the device occasionally with a suitable cloth.
•
Use the supplied dust cover to cover up the microscope
after use.
IF WORK OR REPAIRS THAT ARE NOT DESCRIBED IN THESE OPERATING INSTRUCTIONS ARE
NECESSARY THEN CONTACT YOUR DEALER.
WARNING!
IF FUSES REQUIRE EXCHANGING, THEN THEY MUST BE REPLACED WITH FUSES OF THE SAME TYPES AND
VALUES. THE GUARANTEE IS VOID IN THE EVENT OF EXCESSIVLY HIGH FUSING!
THE DEVICE MAY ONLY BE OPENED BY A QUALIFIED ELECTRICIAN!
8.2 CARE OF THE OPTICAL COMPONENTS
Do not attempt to disassemble optical components.
Please contact the local technical customer service
department for repairs which are not covered by this
manual.
Remove dust from the lens surface with a special brush
prior to cleaning. You can obtain suitable accessories in
any photography store.
Cleaning the oculars: Do not remove the oculars (17) from
the ocular tubes (15).
Clean the outer surfaces. In doing so, breathe on them.
Subsequently dry the lens with suitable cloth or paper for
the purpose. Dry the lens with circular movements from
the centre to the outside. Do not wipe over a dried lens as
they can easily be scratched.
Cleaning and exchanging the protective glass of the eye
protection filter:
Never dismantle the eye protection filter (shutter)!
Only clean the surface. Use a cotton cloth with glass
cleaner.
If the protective glass requires exchanging, slide it
forwards out of the bracket and insert a new protective
glass in the same manner.