Installing your cooker hood (wall mounted)
Remove the grease filters (see page 7).
Hold the hood against the wall in the
intended position and mark the position
of the screw holes that are to be drilled.
Using an 8mm diameter drill, drill holes
in the wall in these positions.
Insert rawl plugs into all of the holes that
you have drilled.
Screw in the upper set of screws leaving 10 mm protruding out of the wall.
Hang the hood onto the upper screws and then fully tighten them.
Screw the lower screws through the relevant holes in the cooker hood and
fully tighten them.
Installing your cooker hood (into a cupboard)
Remove the grease filters (see page 7).
Position the hood against the underside
of the cupboard that you are intending to
install it into and mark the position of the
fixing holes (as shown).
Using a 6 mm diameter drill, make holes
on the underside of the cupboard in the
positions marked.
Position the hood against the underneath
of the cupboard again, making sure that
the holes in the hood line up with the holes that you have just drilled.
From inside of the cooker hood, tighten the screws through the holes in the
underneath of the cupboard.
IMPORTANT: These screws must all be fully
tightened.
Completing the installation
The appliance should now be connected to the electrical supply. See page
13.
Refit the grease filters and then switch on the mains supply to the
appliance. Check that the appliance is operating correctly by selecting each
speed and switching the light bulbs on and off.
Installation
12
