English
Safety instructions and liability
Please also read the enclosed general safety instructions carefully before putting your grooving machine into service.
- When the grooving machine is not in use, before all servicing work, before changing the cutter, etc.: unplug the
cable!
- Ensure that the machine is switched off before inserting the plug in the socket.
- Check plug and cable for damage before inserting. If damage is found, replacement must be made immediately
by a technician (cable type H07 RN-F).
- Make sure before starting the grooving machine that the rated voltage on the name-plate corresponds with the
mains voltage. The machine is only suitable for AC power supplies.
- The grooving machine is double-insulated and (conforming to CEE and VDE re gu la tions) has a two-conductor cable
without ground conductor. The machine can be con nected without risk to an ungrounded socket.
- Do not drill the motor case (e.g. to attach labels) since this damages the double insulation. Use only adhesive labels
for labelling.
- Clamp work tightly if possible and guide machine with both hands.
- Use only perfectly sharpened cutters, since otherwise increased cutting forces may shift the work away.
- Use only cutters rated for manual feed.
- Do not stop the cutter after switching off.
- The baseplate must function sa tis factorily, without jamming.
- The baseplate must not be clamped with the cutter driven out.
- The machine should only be used for the applications described in these operating instructions.
- Do not expose to rain or use in damp lo ca tions.
Manufacturer and retailer disclaim all product liability if the grooving machine is modified in any way from its original
state or condition as delivered, or if the grooving machine is used in a manner inconsistent with operating and safety
instructions.
CE Declaration of normity
We declare under our sole responsibility that this product is in conformity with the following standards or normative
documents:
EN 50144, EN 55014, EN 55014-1/A1, EN 55014-2, EN 61000-3-2, EN 61000-3-3 in accordance with the re gu lations
of directives 73/23/EEC, 89/392/EEC, 89/336/EEC.
Sound emission and vibration acceleration
Typically A-weighted noise levels of the tool are:
Sound pressure level = 88 dB (A)
Sound power level = 101 dB (A)
Wear ear protection!
Typically the hand-arm vibration is below 2.5 m/s
2
.
Karl Steiner
Lamello AG
CH-4416 Bubendorf
10.08.1999
9881131VS_BA_G20 S2_171017.indd 10
17.10.17 08:53
