Lamborghini Caloreclima ALHENA C, Инструкция по использованию, установке и обслуживанию

Страница: 284 / 296

284
cod. 3540000251 - Rev. 00 - 03/2024
EN
ALHENA C
F50 - F53
Limit thermostat fault with
parameter b06 = 1 or 4
No/poor water circulation
in the system Check the circulating pump and hea-
ting system
Air in the system Vent the system
Incorrect parameter Check the correct parameter setting
A64
Maximum number of con-
secutive Resets excee-
ded
Maximum number of con-
secutive Resets exceeded
Disconnect the power supply to the
boiler for
60 seconds and then reins-
tate the boiler
F62 Calibration required
New card or boiler not yet
calibrated
Do complete manual calibration
A88
Specific combustion con-
trol errors or gas valve
Calibration activation with
burner lit.
Combustion problem,
faulty gas valve or PCB Reset the fault and do complete
manual calibration .
If necessary, replace the gas valve or
PCB.
F65 ÷ F98
Specific combustion con-
trol errors
Fume ducts obstructed.
Low gas pressure.
Condensate trap blocked.
Fumes recirculation or
combustion problem
Check that the fume ducts and the
condensate trap are not blocked.
Check the correct gas supply pres-
sure.
Do a manual calibration to adjust the
CO
2
. If necessary, do a complete
manual calibration.
If the problem persists, replace the
PCB.
A65 ÷ A97
Specific combustion con-
trol errors
Fume ducts obstructed.
Low gas pressure (A78 -
A84).
Condensate trap blocked.
Fumes recirculation or
combustion problem
Check that the fume ducts and the
condensate trap are not blocked.
Check the correct gas supply pres-
sure.
Do a manual calibration to adjust the
CO
2
. If necessary, do a complete
manual calibration.
If the problem persists, replace the
PCB.
A98
Too many SW errors or
error occurred during
board replacement
Board replacement
Reset the fault and proceed with
complete manual calibration.
Fume ducts obstructed.
Low gas pressure.
Condensate trap blocked.
Fumes recirculation or
combustion problem.
Initially solve the problem, reset the
fault and check correct ignition.
Do a complete manual calibration
and, if necessary, replace the PCB.
A99 Generic error
PCB hardware or software
error
Reset the fault and check for correct
ignition. Do a complete manual cali-
bration and, if necessary, replace the
PCB.
F96
Specific flame combustion
error Unstable flame or unstable
flame signal after ignition.
Check the gas supply, fume ducts
and condensate drain. Check the
correct position and state of the elec-
trode After about 3 minutes the error
is reset.
A44 Multiple requests error
Repeated short-term
requests
Check if there are pressure peaks in
the DHW circuit. If necessary, modify
parameter b11.
A80
Parasite flame signal after
valve closing
Electrode problem.
Gas valve problem.
PCB problem.
Check the correct position and condi-
tion of the electrode.
Check the PCB.
Check the gas valve and replace it if
necessary.
Fault code Fault Possible cause Cure