lamber P550-dy-CVP-S, Инструкция по эксплуатации

Страница: 15 / 46

15
DRAIN PUMP INSTRUCTIONS (optional)
(only for machines with drain pump)
The pump discharge function allows you to
automatically download the wash tank at the end
of the workday.
machine«OFF»
Door
open
Remove the
overflow
1
2 3
keep
button
pressed
for 3 sec.
The operation of the discharge pump
is
automatic only during the cleaning cycle to
drain the excess water that enters during the
rinsing phase
At the end of the working day, to discharge
the tank completely,
you must perform the
following steps:
-1
Put the machine OFF by pressing the
switch “A” (the display shows LAMBER
logo);
-2
Open the door of the machine;
-3
Remove the OVERFLOW from the tank
4- Then press the “B” cycle-button for 3
seconds
Alternately flash the words “DRAIN” and
“REMOVE OVERFLOW”
(N.B. The word “REMOVE OVERFLOW” will
disappear only to the closing of the door)
The discharge stops automatically after about 5
minutes.
The discharge can be interrupted at any time by
pressing the cycle-button
“B”
After drainig, the machine will turn off
completely (display OFF).
Replace the overflow into place and close the
door.
DESCALING (optional)
(only for machine with drain pump and
dispenser )
The descaling function
is a cycle that leads
descaling liquid in the pipelines of rinsing, in the
washing tank and boiler allowing the removal of
limescale deposits from the water products.
The cycle lasts about 35 minutes.
For an average water limestone is recommended
cycle activation at least once a week.
The frequency may vary depending on type of
water.
machine «OFF»
Door
closed
Remove the
overflow
keep
button
pressed
for 3 sec.
keep button
pressed for 3 sec
and w
.
ait the End
of the drain
1
2
3
4
To make the cycle do the following operations:
-1
Punt the machine OFF by pressing the
switch “A” (led off)
-2 Remove the OVERFLOW from the tank;
-3 Press the “B” button for 3 seconds and
wait for the complete emptying of the
tank;
-4 Close the door of the machine;
-5 Then press the “E” button for 3
seconds
At the end of the descaling cycle (approx. 35
minutes) will appear on the LED the words
“END OF THE DESCALING CYCLE”.