lamber P440-ek, Инструкция по эксплуатации

Страница: 40 / 55

40
WATER CONNECTIONS
Carefully comply with any national or regional
regulations in force.
Water installation must have the following
characteristics:
Temperature : 55°C (P440-ek)
Dynamic Pressure
:
-
2 ÷ 4 bar (200÷400 kPa);
For machines with steam condenser P440-CV:
Temperature
: 10÷12 °C .
ATTENTION!: do NOT connect to softened
water.
WARNING!
If the water pressure is higher than 4 bar, fit the
pressure reducer “A” supplied into the solenoid
valve as shown in the drawing.
If the dynamic pressure is lower than specified
on the data plate of the machine, it is advisable
to install a Booster Pump.
Hardness:
between 7,2 and 12,5 °French .
If the hardness values are higher than
those mentioned above, it is advisable to install
a water-softener.
WORKS TEMPERATURES
Water temperature 55°÷60°C
Rinse temperature 80°÷85°C
n.b.:
To help a correct working of the
thermocontrol system, do NOT adjust the
thermostat during the washing cycle.
DO NOT TAMPER WITH THE THERMOSTAT
CALIBRATION
WATER DRAIN
According to the dimensions of the drawing;
water drain and feeding pipe should have the
same diameter as the water inlet of the
machine.
It must be furnished with a siphon and have
a right slope.
The machine is provided with a flexible pipe for
the connection with the water-work.
Make sure there are no throttlings along the
pipe.
Carefully comply with any national or regional
regulations in force.