22
REGENERATING
(for machines with Water-softener)
If the glasswasher is equipped with a Water-
softener it is possible to
Regenerate
the water
(water cleaning).
Every evening, after MAINTENANCE
operations, lift the overflow out of the tank,
close the door and push the switch
"A"
on the
OFF position.
Push the button
"R"
until the lamp
"H"
is
lighted. After twenty minutes the lamp
"H"
is
OFF.
Every 6 days add 1 kg of salt in tablets into the
bottle placed on the bottom of the tank.
Attention!: the regeneration starts only when
the machine is on the OFF position.
SALT CONTROL
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it.
Clean the gasket and screw the plug.
The lack of sault in the container causes
damages for the machine because of limestone,
besides a defective washing of glasses and
dishes.
DISHES POSITIONING
It is suitable to place dishes, inside the plastic
basket with the concave side facing upwards.
Place mixed cutlery in a vertical position into
the suitable container minding not to cram them
and with handgrips towards the bottom (see
drawing).
CLEANSING AGENTS
Choice of the suitable cleansing agent is an
essential condition if you want to obtain
extremely good washing results as regards
hygienic results. It is then important to consider
some points. First of all only highly alkaline and
chlorine-active antifoam products, especially
made for industrial dish-washing machines,
must be used and they must be produced by
well-known reliable Firms. Mean concentration
of the cleansing agents in powder must be
1,5÷2,5 g/lt. Mean concentration of liquid
cleansing agents must be 2÷4 g/lt.
In order to avoid scales and corrosions, put the
cleansing agent above water level on the
nearest area of the sucking pump filter, in this
way it will immediately dilute and will not deposit
on the tank bottom.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and
cups you must add a surfactant on water
(Brightener).
Your cleansing agent supplier will be able to
suggest the most suitable product. Your
machine is equipped with a rinse aid dispenser.
Mean concentration used is 0,15 g/lt.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump automatically starts up at
each cycle
to discharge the exceeding water
coming from the rinsing cycle.
In order to completely discharge the tank
it is necessary to perform the following
operations:
1. Switch the machine main switch
"A"
off;
2. Remove the overflow from the tank;
3. Soon afterwards press the drain pump
pushbutton
"P"
(the lamp
"H"
is lighted)
.
After the water has completely flowed down,
press the drain pump pushbutton
"P"
to
switch the pump off.
WARNING!
DO NOT FORGET THE PUSHBUTTON "P"
ON "ON" POSITION; THIS CAN CAUSE
DAMAGES TO THE PUMP.
