Lambda Labs CX-1A, Руководство пользователя

Страница: 11 / 25

Lambda Labs - Professional Acoustics CX-1A/B Manual
2.2 Figure 2: CX-1A Back & Bottom Side
www.lambda-labs.com ! 10
e)
f)
g)
g)
h)
PART DESCRIPTION of 2.2 Figure 2 REFERENCE
e)
Amplifier Module
The built in bi-amp module delivers 800W plus 200W RMS power. It comes with
4 ready to use presets to match the various loudspeaker setups and the use of
further products like additional subwoofers.
Chapter
2.2.1
f) Second Independent Safety Link
By removing the dummy screw, an M10 ring eye can be inserted to safe the
loudspeaker from accidently falling with a second independend safety link.
Chapter 2.2.3
g) Rubber Feets
7 rubber feets, attached to the loudspeaker`s bottom and monitor side, make
the loudspeaker stand safely in both vertical and horizontal position.
_
h) Adjustable Speaker Flange
The loudspeaker can be tilted down- or upwards by adjusting the angle in 4.5°
steps. The maximum possible tilt angle is +/- 13,5°. The stand adapter is
suitable to use with a stand/distance rod tube diameter of 35mm. Lambda Labs
recommends the use of products with the „Ring Lock“ system.
Chapter 2.2.2
i)
Speakon Out
The CX-1A is able to additionally power up to 2 CX-1B loudspeakers to extend
the reinforced area. The maximum power of 500W RMS for each CX-1A/B can
be reached with one CX-1A combined with one CX-1B. Operating 2 CX-1B, each
CX-1A/B get 400W RMS amping power. The CX-1B operates in bi-amped mode.
Therefore, the speakon connector has to be wired with 4 poles.
i)
Caution: Never connect more than two CX-1B on one CX-1A, because a critical low impedance will be
reached for the active module. Furthermore 2 different CX-1A should not be connected with their
speakon outputs in any case. Make sure that you never use a crossed cable, because this could lead to
the damage of the high frequency unit.
R
CAUTION!