Lakeland Mills CF1128, Руководство пользователя

Страница: 4 / 4

Place barrel nut into horizontally drilled hole in end of swing
bar. Position barrel nut with screwdriver and screw in 5” eye-
bolt with 3/8” washer as shown.
TIGHTEN DOWN SE-
CURELY! Repeat on other swing bar. Figure 7
Fasten swing bars to side of unit as shown. With hammer, tap a
5” hex washer head screw through the bottom hole in swing bar
and into pilot hole (11” from the back of the seat end) on seat
end. Tap 5” hex washer head screw through the upper hole in
the swing bar and into arm about 1/2” deep at the point 15” from
the back of the arm. (
This gives a suggested pitch of the seat.
You may change the pitch by altering the location of the hex
washer head screws in the arm.)
Tighten down hex washer
head screws. Figure 8
STEP 7
STEP 8
Pilot holes is 11” from the
rear of the seat end.
Figure 7
Figure 8
If you have hardware left over after completing your unit, it
most likely has been assembled incorrectly, and may not be
safe to use. Please call Customer Service at 800-427-5136 for
assistance.
NOTE
SEAT TO FRAME ASSEMBLY
Install the assembled swing to the frame. It is recom-
mended a minimum of two people for this this step. STEP 9
STEP 10 Tighten all hex washer head screws firmly. Your unit is
now ready for finishing or immediate use. Relax and en-
joy.
Install on level ground. Install not less than 6’ from any
obstructions such as a fence, garage, house, overhanging
branches, lines, or wires.
Check all nuts and bolts for tightness
before and during each usage season. NOTE:
Factory: 1 Lakeland Place, Edmore, Michigan 48829, Phone: 800-427-5136 Fax: 989-427-5824
www.lakelandmills.com
Look for assembly videos on:
https://www.youtube.com/watch?v=jg2BRgWMVpg&t=1s
https://www.youtube.com/watch?v=-OmqxSrmkYM
Lakeland Mills recommends:
WeatherSeal Premium Oil-Based Exterior Wood Stain & Sealant
www.ContinentalProd.com