STEP 2
STEP 4
STEP 3
STEP 6
STEP 5
Lay assembled seat on ground. Insert doweled ends of
uprights of the assembled back into the 1 1/4” holes in the
back rail of the seat (
adjusting uprights in or out as needed
to align properly with holes).
Do not tap on seat back
with hammer.
To keep the back rail from splitting, lay the back on
the ground and drive the seat on by hitting the bottom of
the seat assembly. Figure 1.
Insert the 12” arm support into the 1 1/2” hole in the arm,
then insert other end of arm support into the hole of the
seat end. Drive dowels in as far as possible.
Fasten arm to back frame. Align the predrilled hole in the
back of the arm with the predrilled hole of the back up-
right . The back upright has a preinstalled lag bolt, tighten
the 1/4” x 5” lag screw into the pilot hole of the arm with a
wrench, socket, or power drill. Repeat process for the
other arm. Figure 2.
figure 2
Secure all dowel joints in place with screws perpendicular
to the doweled end as shown. Figure 3
Place barrel nut into horizontally drilled hole in top
end of swing bar. Position barrel nut with screwdriver
and screw in 5” eyebolt with 3/8” washer as shown.
TIGHTEN DOWN SECURELY!
Repeat process for
other swing bar. Figure 4
figure 3
figure 4
Fasten swing bars to side of unit as shown in figure 5.
Measure 15” from the back of each arm and mark
with pencil. (This gives a suggested pitch of the seat.
You may change the pitch by altering the location of
the lag screw in the arm.) With hammer, tap a 5” hex
washer head screw through the bottom hole in swing
bar and into pilot hole on seat end. Tap a 5” hex
washer head screw through the upper hole in the
swing bar and into the arm about 1/2” deep at the pen-
cil marked position on the arm. Tighten down lag
screws.
figure 5
Pilot hole is 11”
from the rear of the
seat end.
Look for videos on:
If you have hardware left over after
completing your unit, it most likely
has been assembled incorrectly, and
may not be safe to use. Please call
Customer Service at 800-427-5136
for assistance.
Factory: 1 Lakeland Place, Edmore, MI 48829, Phone: 800-427-5136, Fax: 989-427-5824
www.lakelandmills.com
NOTE: Check all nuts and bolts for tight-
ness before and during each usage season.
Figure 7
Lakeland Mills recommends:
WeatherSeal Premium Oil-Based Exterior Wood Stain & Sealant
www.ContinentalProd.com
https://www.youtube.com/watch?v=jg2BRgWMVpg&t=1s
