lakeair WM-RC2 120 Volt, Руководство по эксплуатации и обслуживанию, Страница: 9 / 15

9
Electrostatic Cell Removing and Re-installing
CAUTION
Always Ground the Cell before handling!
When you open the door to the
Unit all power is cut off. It is
possible however that some
residual electricity is still residing
in the Filter Cell. So, the FIRST
thing to do is ground the voltage
side of the cell. To do this take a
Philips screw driver with an
insulated handle and touch both
the cell side and the ION Bar. This
will dissipate any residual charge.
Remove the ground screw. The
ground screw secures the filter
cell and provides the ground
needed to allow the filter cell to
function properly
Slide the cell out slowly, The Cell
Power Line is on the left hand side.
With the Cell partially out remove
the Power Line Plug. by
disconnecting from the Cell Power
Lug. Then remove the cell from the
air purifier.
To re-install:
reverse these steps,
be sure that the power line is with
the cell frame and avoid crimping
the power. Line