Laird ConnexLink CL2510, Руководство пользователя

Страница: 21 / 28

18
www.lairdtech.com Laird Technologies
CL2510
RF Transceiver
There are three typical hardware setups.
1. One radio is plugged into a serial or USB port on a PC. The second radio is plugged into a separate
power supply with a loopback adapter connected.
2. One radio is plugged into a serial or USB port on a PC. The other radio is plugged into a different
serial or USB port on the same computer.
3. One radio is plugged into a serial or USB port on a PC. The other radio is connected to a serial or
USB port on another PC.
If using two PCs for the test, the application run on both sides should have the second COM port disabled
on the PC Settings tab.
TABLE 5:
TEsT sELECTION POrT 1 ACTION POrT 2 ACTION HArDWArE sETuP
Port 1 -> Port 2 TX rX 2
Port 2 -> Port 1 rX TX 2
Port 1 <-
>
Port 2 TX/rX TX/rX 2
Port 1 send Only TX n/a 3
Port 1 receive Only rX n/a 3
Port 1 Loopback TX/rX n/a 1
Transmit Packet Selection
This section allows you to select the data packet used to perform the Range Test. You may either create data
of a specified byte length or load your own text or configuration file.
Test Type
The test type allows you to select how long the test will be performed. The choices are shown in the
following graphic:
• Continuous: Test will run until stopped.
• Timed: Test will run for a specified time period.
• Number of Runs: Test will run for a specified number of runs.
• Single Step: Test will run for a single step.
• Break on Error: Test will run until an error occurs.
Receive Packet Display
This section allows you to select how the received packets will be displayed. The user is provided the
following options:
• ASCII or Hexadecimal format
• Packet Time Stamp
• Only Display Errors
Timing
This section allows you to modify the TX and RX timing of the test.
TX Delay
This field allows the operator to change the amount of delay between transmissions (in milliseconds {ms}).
RX Timeout
This field allows the operator to change the amount of time allowed for a packet to be received before a
Data Timeout error is reported.
CONFIgURATION
SOFTWARE
OVERVIEW