Bx600 Series of Breakout Boards for BL600 module
User Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
21
Laird
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
Figure 18: SIO_7 is brought out onto J5 pin 5
To initiate Command mode, follow these steps:
1.
Switch the BL600 out of autoRUN mode by doing the following:
a.
Remove the CR1632 coin cell battery.
b.
Move the nAutoRUN jumper between pins 2 and 3 of J5 to pull it high.
c.
Connect the BA600-0x to the Laird FTDI USB-UART bridge board (
Figure 19
).
Figure 19: BA600-0x connected to the USB-UART bridge board
In UwTerminal, you will notice that the BA600-0x is in Develop/Interactive mode rather than AutoRUN
mode (
Figure 20
).
Figure 20: Develop/Interactive mode
