Bx600 Series of Breakout Boards for BL600 module
User Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
12
Laird
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
Figure 5: BB600 breakout board
2.3.4
Powering the BB600 Breakout Board
This section refers to the
Bx600 Breakout Board schematic
.
Several options exist to power each of the BL600 breakout boards (see section
4. Power Supply Options for
BL600 Breakout Boards
) however the BB600 will require added components prior to supplying power to the
board. The easiest solution for the BB600 is listed below and more options can be found in section 4.
Note:
At a minimum, the decoupling capacitor, C2 (0.1uF,0402), located near the VCC input pin of the
BL600 module should be fitted on the BB600 to eliminate noise at the supply input.
WARNING: The maximum allowed VCC for BL600 is 3.6V.
J5 – Removed
SIO_7 and (SIO_28)
nAutoRUN
PTH via holes (1.27 mm pitch)
bring out BL600-07
pins SIO_1 to SIO_8 and SIO_25 to SIO_30
J2 – Removed
CR1632 Battery Coin-cell Holder
J3 – Removed
J3 (UART)
PTH via holes (1.27 mm pitch)
bring out BL600-07
pins SIO_8 to SIO_20.
Top
Bottom
