©
2021
鸾翼科技
版权所有
8
2. The dovetail lock system is designed to ensure reliable camera security. When installing the camera, always
hold the camera with at least one hand until it is firmly fixed. To install the camera to the PTZ, follow the steps
below:
a. Open the plate lock which is on the side of the camera mounting base. (As shown in Figure 1)
b. Place the plate against the passive side of the PTZ, place your hands on the camera, and tilt the plate into the
dovetail lock. (As shown in Figure 2)
c. The weight of the camera will press the dovetail lock and make the plate lock, you will hear a click. (As shown in
Figure 3)
d. The camera and plate can be moved back and forth to adjust the balance (the safety block can prevent the
camera from sliding out), fastened and locked. (As shown in Figure 4)
Tilt axis adjustment
If you find that the up/down space is insufficient when installing the camera, you can adjust the tilt axis and the
up/down position of the handle. Loosen the tilt axis fixing buttons on both sides respectively, adjust as required,
and ensure that the scales on both sides are exactly the same. After the adjustment is completed, be sure to
tighten the screws on both sides. (This height has been adjusted before leaving the factory, and it is suitable for
general camera heights.)
