Copyright © 2020 Laia · www.laiatech.com
All rights reserved
3) Youtube: Fill these two parameters in the "Host Address" and "Stream
Name" of the camera as you will see in the following image.
3.1) Facebook: Fill these two parameters in the "host address" and
"stream name" of the camera, and change the port to 443.
IMPORTANT: If the camera reboots, you will need to click on
"save" to republish to streaming.
Some models may need to open the audio settings to launch the
broadcast normally. If you can't broadcast the audio according to the
above method, please try to activate the audio according to the image
below.
1
4
Maintenance and
troubleshooting
MAINTENANCE
1) Please power off the camera and disconnect the power adapter and socket,
if it’s not used for a long run.
2) Use soft cloth or tissue to clean the camera cover.
3) Wipe it with a soft, dry cloth when cleaning the camera lens. Wipe it gently
with a mild detergent if needed. Do not use strong or corrosive detergents to
avoid scratching the lens and affecting the video quality.
TROUBLESHOOTING
1)No video output
a. Check whether the camera power supply is connected, the voltage is
normal, the power indicator is lit.
b. Whether the machine could do self-check after restarted.
c. Check whether the bottom of the DIP switch is the normal operating mode
(see Table 2.2 and Table 2.3)
d. Check whether the video output cable or video display is normal
2) Image flickering issue.
a. Check whether the video output cable or video display is normal
3) Video dithering when zoom-in or zoom-out
a. Check whether the camera installation position is solid
b. Whether there is shaking machine or objects around the camera
4) Remote control not works
a. Remote control address is set to 1 (if the machine is set back to the factory
defaults, remote control addresses need to be back to 1 too)
b. Check whether the battery is installed on the remote controller or low .
c, Check the camera working mode is the normal operating mode (see Table
2.2 and Table 2.3)
d. Check the menu whether is closed, camera control through remote
controller is only available after exiting the menu. If video output from LAN,
menu will not be displayed, menu will automatically exists 30s later, and then
it can be controlled by remote controller.
5) Serial port not works
a. Check whether the camera serial device protocol, baud rate, address is
consistent
b. Check whether the control cable is connected properly
c. Check whether the camera working mode is the normal operating mode
6) Web pages cannot log in.
a.
Check if the camera outputs video normally by connecting directly to the
screen.
b.
Check whether the network cable is connected properly (Ethernet port
yellow light flashes to indicate normal network cable connection)
c.
Check whether your computer is added the segment and the segment is
consistent with the IP address of the camera
d.
Click "Start" and select "Run" and then type “cmd” in the computer; Click
"OK" then turn on a DOS command window to enter ping 192.168.5.163.
