laguna SuperMax SuperBrush 49, Руководство пользователя

Страница: 18 / 42

LAGUNATOOLS.COM 18
9. Check alignment (parallelism) of the brush head to the conveyor. Measure
from the bottom of the brush bristles to the top of the conveyor belt on the right
and left side. If the brush head is not parallel;
A. loosen the two bearing bolts (that secure the bearing to the machine)
on the lower side of the brush, Fig. 8.
B. Raise the bearing on the low side by using a hex wrench in the center
of the bearing stud and rotate both equally until the brush head is
parallel.
C. Tighten the bolts attaching the bearing to the machine bracket.
Figure 8: Aligning Brush Head
Dust Collection, Connection/Assembly
1. Connect dust collection
hose to each 4” port on machine. Minimum of *600
CFM per port.
*NOTE: The CFM requirement can vary depending on brush head, application(s) and material.
Figure 9: Dust Ports
Bearing Bolts
Bearing Stud
Dust Ports (3)