laguna SPS-9, Руководство пользователя

Страница: 18 / 39

18
C-5 Abrasive belt tracking
There are 2 limit switches installed on sides of abrasive belt for
preventing abrasive belt from moving out of track, when either side of
limit switch is activated, the machine stops running.
1.
Open the sanding head case and check which side limit switch is
activated.
2. Pull down the cam tension handle to loosen abrasive belt tension and
move abrasive belt to the center of rollers, then release the cam tension
handle.
3. Close the sanding head case, check if power lamp is ON.
4. Slightly turn the belt track adjust knob to adjust the belt track, referring
to the view from conveyor in-feed side:
⚫
If the belt tracks toward to the left, turn the belt track adjust knob
clockwise to adjust belt tracking toward to the right.
⚫
If the belt tracks toward to the right, turn the belt track adjust knob
counter-clockwise to adjust belt tracking to the left.
Abrasive belt replacement:
1.
Turn OFF the machine and wait for it to come to a complete stop.
2. Open the sanding head case for access to the abrasive belt.
3. Pull down the cam tension handle to loosen abrasive belt and remove it
from the rollers.
4. Install the new abrasive belt, positioning the arrow printed on the inside
of the belt with the direction of the roller rotation.
5. Center the abrasive belt on the rollers.
6. Release the cam tension handle to tighten the abrasive belt.
Cam tension
handle
Belt track
adjust knob
View from sanding
motor side
View from conveyor
in-feed side
View from the
sanding head case
side