
18
Raising and Lowering Table
Turn the handwheel A (Fig. 7) clockwise to raise the
table. One revolution equals 1/32” or 0.03”.
Note: The handwheel is spring loaded.
Push in on the handwheel and rotate until
the pins engage the detents.
Adjusting Thickness Scale
1. Run a board through the planer and measure the
thickness of the planed board with a pair of
calipers.
2. Adjust the pointer B (Fig. 7) by loosening the
screw that holds it in place.
Note: This measurement should be the
same as digital readout.
Table Roller Adjustment
Loosen the handle C and move the table rollers up,
or down by raising, or lowering the handle D.
When you reach the desired position tighten the
handle (Fin. 7).
The rollers are usually set higher when planning
rough stock. When planning smooth stock the table
rollers should be set slightly above, or flush with the
table.
Changing Feed Rate
The planer has three selectable feed speeds that
feed stock at 20, 25 and 30 feet per minute.
To adjust speed, turn lever E (Fig. 8) until
it clicks into place. Change feed speed
only while the feed system is RUNNING!
Table Stop
The socket head cap screws F (Fig. 8) act as a stop
and prevent you from running the table into the
cutting and feeding assembly.
Opening Hood
Turn the locks G to open the hood. The hood will
open automatically. Use the handle H to shut
the hood (Fig. 8).
Содержание MPLAN25-15-3-0130
