7
CONTROL THE DEPTH OF CUTTING
The cutting depth scale is a combination of
inch / metric scale, the cutting range is from
0 to 8" (204 mm). The distance between upward
or downward of driving handle is 0.059" (1.5mm)
one complete turn.
Before adjusting the table upward, or downward;
loosen nut 1, after positioning to required position,
tighten nut 1 again to hold in position. (Fig.15)
CHECKING PULLEY
To verify that motor pulley (B) is in line with
the shaft pulley of (A), using the edge of a straight
scale check to see if they are on-line with each
other.(Fig.16).
ADJUSTING MOTOR MOUNT
If motor pulley B and shaft pulley A, are not on-line
loosen screw as shown in (Fig.17), move shaft to
left and right until adjusted to proper position and
tighten the screw again.
ADJUSTING BELT TENSION
Use the two bolts to adjust the belt tension (Fig.18)
When achieved proper position of adjustment
tighten bolts to hold in place.
Fig. 18
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Содержание MPLAN2010-0130
