5
SHEARTEC 2 CUTTERHEAD
Knife inserts are dangerously
sharp. Use extreme caution when inspecting,
removing, or replacing knife inserts.
The knife inserts on the Jointer are four-sided.
When dull, simply remove each insert, rotate it
90° for a fresh edge, and re-install it. No further
adjustment is necessary. Use the two provided
torx wrench to remove the knife insert screw. Use
one of the torx wrenches to help hold the
cutterhead in Position, and the other to remove
the screw. See Fig. 7. It is advisable to rotate all
inserts at the same time to maintain consistent
cutting. However, if one or more knife inserts
develops a nick, rotate only those inserts that are
affected.
Each knife insert has an etched reference mark
so you can keep track of the rotations.
IMPORTANT:
When removing or rotating inserts,
clean saw dust from the screw, the insert, and the
cutterhead platform. Dust accumulation between
these elements can prevent the insert from
seating properly, and may affect the quality of the
cut.
Before installing each screw, lightly coat the screw
threads with machine oil and wipe off any excess.
Securely tighten each screw which holds the knife
inserts before operating the jointer!
Make sure all knife insert screws are tightened
securely. Loose inserts can be propelled at high
speed from a rotating cutterhead, causing injury.
from a rotating cutterhead, causing injury.
Fig. 7
Содержание MPLAN2010-0130
