laguna DT-18, Руководство пользователя

Страница: 17 / 57

Operation 17
Operation
Adjusting the Height of Male Indent:
A1.) Adjusting the Height (H) of Male Indent
Loosen Screw (B)
and then Adjust Shaft (C) could move the Spindle (A) in a Up/Down-Ward motion .
When you are adjusting the height, you must notice the Height of Cutter head (D) , to avoid the cutter head to
against the board.
Make sure to position the milling cutter on the
bottom of the spindle when adjust the height of
workpiece. Failure to comply with this may result
in damage of drill bit and positioning frame.
A2.) Adjusting the thickness(s) of male indent. Move the Mold (A) , to positioned to the limited back. Take off the
Cover, Loosen the Screw (B) , A djust (C) with Hexagonal Wrench ,
then tighten the cover.