Laguna Tools Smartshop II, Руководство пользователя

Страница: 43 / 51

41
18) Press the MAN membrane switch to access the Manual control screen.
19) Turn on the vacuum pump in order draw the spoil board flat to the
machine's table.
20) Using the Jog functions, lower the Z axis to the top of the spoil board until
it just touches the top of the MDF sheet.
21) Press TOOLS membrane switch to access the tool table screen.
22) Verify that TOOL 8 is selected in the tools drop-down menu.
23) Press Teach Tool Length to teach the system the tool position at the top
of the spoil board.
24) Press Set Tool Data to write the value to the controller.
25) Tool setup is now complete for the fly cut program. Press the RUN
membrane switch to continue.
Machine and System are ready for the program run as described below
1)
Press RUN membrane switch to access the RUN screen.
2)
Verify that the fly cutting program (usually CNFLY.prg) is listed as Active
Program at the top of the screen.
3)
Verify “TOOL 8” is listed as ACTIVE tool in the active tool field.
4)
Make sure the Vacuum Pump and Dust Collection System are turned on.
5)
Keep all personnel clear of the machine.
6)
Press START Membrane switch to begin the Fly Cut program.
7)
Once the Fly Cut program has completed, vacuum and blow off all the
dust from the machine and spoil board.
8)
Flip the MDF sheet and repeat steps above to fly cut the flipped side so
both surfaces are flat and free from resin to increase vacuum flow. (It will
be necessary to touch off the fly cut tool again before machining the back
surface of the spoil board.)
9)
With the spoil board fully prepared, lift one corner of the spoil board and
measure with dial calipers to get a measurement to 3 decimal places.
10)
Go to the second Tools screen and input the dimension (thickness) of the
spoil board into the field Zspoil. This dimension is used to adjust the tool
length so that the top of the spoil board becomes a known location for the
program to reference as work coordinates.